Instrument Cluster Replacement

Instrument Cluster Replacement

Removal Procedure

Note: The ignition switch must be in the OFF position when removing the instrument cluster assembly.

1. Remove the IP cluster trim panel. Refer to Instrument Cluster Trim Panel Replacement (Instrument Cluster Trim Panel Replacement).




2. Remove the three screws.




3. Pull out the instrument cluster and disconnect the electrical connector.
4. Remove the instrument cluster assembly.

Installation Procedure




1. Connect the electrical connector.
2. Install the instrument cluster assembly.




3. Install the three screws.
4. Install the IP cluster trim panel. Refer to Instrument Cluster Trim Panel Replacement (Instrument Cluster Trim Panel Replacement).