Heated Oxygen Sensor Replacement - Sensor 2

Heated Oxygen Sensor Replacement - Sensor 2

Special Tools

J-39194-C - Oxygen Sensor Wrench

Removal Procedure

1. Disconnect the heated oxygen sensor connector.
2. Separate the wire harness grommet.
3. Remove the heated oxygen sensor for AWD.




4. Using the J-39194-C - wrench (1) , remove the heated oxygen sensor.




5. Disconnect the heated oxygen sensor connector (1).
6. Remove the heated oxygen sensor for FWD.




7. Using the J-39194-C - wrench (1) , remove the heated oxygen sensor.

Installation Procedure




1. Install the heated oxygen sensor for AWD.

Caution: Refer to Fastener Caution (Fastener Caution).

Note: This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and the J-39194-C - wrench with 30 mm (1.18 in). This torque value is effective when the J-39194-C - wrench is parallel to the torque wrench.

2. Using the J-39194-C - wrench (1) , install the heated oxygen sensor and tighten.

* Without the J-39194-C - wrench to 44 Nm (32 lb ft)
* With the J-39194-C - wrench to 40 Nm (30 lb ft)

3. Connect the wire harness grommet.
4. Connect the heated oxygen sensor connector.




5. Install heated oxygen sensor for FWD.

Note:
* This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in) and a J-39194-C - wrench with 30 mm (1.18 in)
* This torque value is effective when a J-39194-C - wrench is parallel to the torque wrench.

6. Using the J-39194-C - wrench (1) , install the heated oxygen sensor and tighten.

* Without the J-39194-C - wrench to 44 Nm (32 lb ft)
* With the J-39194-C - wrench to 40 Nm (30 lb ft)




7. Connect the heated oxygen sensor connector (1).
8. Inspect for exhaust leaks.