22. Low and Reverse Clutch Piston Removal

Low and Reverse Clutch Piston Removal

Special Tools

J-47339-1 Piston Return Spring Compressor




1. Using a press and J-47339-1 (1), compress the low and reverse clutch piston spring.

Note:
* Stop pressing when the spring seat is 1-2 mm (0.039-0.078 in) from the snap ring groove to prevent the spring seat from being deformed.
* Do not expand the snap ring excessively.

2. Using snap ring pliers, remove the snap ring.
3. Remove the return spring.





Note:
* Applying compressed air may cause the piston to jump-out. When removing the piston, hold it by hand using a piece of cloth.
* Take care not to splash ATF when applying compressed air.

4. Apply compressed air to the transaxle case (2) to remove the low and reverse clutch piston (1).




5. Remove the O-rings (1, 2) from the low and reverse clutch piston.