Section 19

ADJUSTING SLIP CLUTCH ON LIFTING ROOF MOTOR

Note:





The slip clutch is adjusted in the factory and should only be readjusted if the adjusting screw has been unscrewed completely for manual operation. The lock nut of adjusting screw is cemented and is 2.5 mm away from the head of the screw.

To guarantee correct functioning of the slip clutch, the adjustment should be made by measuring the power input of the lifting roof motor.

1. Remove fuse no. 9 from the auxiliary fuse panel. Connect ampmeter across fuse carrier no. 9.

2. Screw in adjusting screw on slip clutch and tighten slightly.

3. Turn on ignition and operate lifting roof to final position of drive with the rocker switch. Measure power input in final position (clutch slips).

4. Tighten the adjusting screw until the power input is approx. 12 to 14 A.

5. Disconnect ampmeter and and reinstall fuse (25 amps.)