Distributor Drive Gear - Installing Onto Crankshaft
83porsche03Subject:
Installation of distributor drive gear on crankshaft
Part Identifier 1371
Applies To 911 Carerra
1984
Group
13
Key Points Gear must be properly installed on crankshaft
C
Number
83-04
December 8, 1983
It is essential to install the distributor drive gear properly on the crankshaft during repairs.
Caution
Incorrect installation will cause initial ignition timing to be off by approximately 13~.
Installation procedure
Gears marked with P only (Porsche registered trademark) -P should face the V-belt drive pulley
Gears marked with an additional X (scribed with an electric engraver)
- X should face the V-belt drive pulley. The location of the P on this gear does not matter.