Sunroof / Moonroof: Adjustments

ADJUSTING LIFTING SUN ROOF

Following jobs must be completed before adjusting.
- Lifting sun roof removed.
- Trim on rear roof frame removed.
- Edge guard and roof liner on rear roof frame loosened on body partially (refer to "Removing/Installing Drive and Assembly" - points 6 through 10). Service and Repair


Adjusting




1. Place edge guard on collar, install roof, arrest and adjust element guides in slots that lifting roof lid and car roof are in same plane. Tighten mounting screws.

2. Remove roof and pull off edge guard, cement roof liner on body and slide on edge guard. Screw trim panel on roof frame and install caps on heads of screws.







3. If staybolts of element guides are not in neutral position + 3 mm (see sketch), left trim panel must be removed in luggage compartment and excessive deviation eliminated by adjusting the switch lever on the rail.

4. Install trim panel again after finishing adjustment.




5. The gates bolted on the lifting roof lid have slots, with which the lifting roof lid and car roof panel can be adjusted to be in the same plane. Check gate guides, replacing if worn or damaged.




6. Cable anchors located in the lifting roof lid must be adjusted that the cable of the lifting roof runs parallel to the cable of the car roof.




7. Should the lifting roof lid protrude at the front, the centering wedges must be unscrewed on the roof beam and installed again with washers underneath.