Drive Belt, Alternator

CHECKING AND ADJUSTING
- Remove engine splashguard.

Adjusting Rod:

- Loosen connecting rod hex bolts slightly. Loosen connecting rod nuts and turn back connecting rod one turn (reduces tightness).
- Prepare Special Tool 9201 for checking operation. Pull out lockpin in special tool and push out test pin opposite lockpin completely. Line up drag needle with gage needle.

Checking Tension:

- Slide special tool onto belt. Press in gaging pin (arrow) slowly until lockpin is felt to engage, and read value indicated on dial gage. Adjusting value: 9.5 scale units. From this position, turn the connecting rod one more complete turn (increase tension).

NOTE: Slides must be in perfect contact with drive belt. The special tool must not be turned or moved on drive belt during checking.