Work Procedure: Overview

Radio removal

1. Remove radio trim plates (where applicable)

2. Insert radio removal tools into radio front panel and pull out radio. Disconnect six pin connector, DIN cable and antenna cable.


3. Remove glove box door and glove box.





Wiring harness installation

4. Plug relay RL-107 into relay connector P-104. Secure relay to wire harness with a wire tie.

Plug J-105 into six pin vehicle harness radio connector and plug P-106 into back of radio. Reconnect DIN and antenna cable to radio and reinstall radio. Route the remaining harness downward to the right of the center console.