Gear: Service and Repair

Disassembly/Assembly

Gearbox:

Legend:

- Refer to legend for disassembly instructions.

Assembly





- Heat gearbox to approximately 120°C and, using special tools P254 and P 254 b, press cylindrical roller bearing outer race for input shaft in until correctly seated.





- Heat gearbox to approximately 12O°C and using special tool P 254 and P 254 a, press in cylindrical roller bearing outer race for drive pinion until seated.





- Using special tool 9254, press in bearing sleeves until flush.

NOTE: Refer to legend for additional assembly instructions.