Disassembling/Assembling Oil Pump

DISASSEMBLING AND ASSEMBLING OIL PUMP






No. Description Qty. Notes

1 Shaft seal 1 Replace, lubricate lip with oil, install seal
38 x 55 x 7 together with toothed sleeve and drive in with tool 10-203 (only outer part)

2 Toothed sleeve 1

3 Countersunk screw 2 Torque: 8 Nm (6 ft lb)
M 6 x 25

4 Housing insert 1 Apply coat of Loctite No.574 on outside diameter of housing insert over entire width before installing

5 Inner rotor 1 Lubricate with oil

6 Outer rotor 1 Lubricate with oil; punch mark faces out

7 Oil pump housing 1 Coat face end with Loctite No.574