Removing

Removing

1. Remove final muffler.

2. Unscrew joint shafts on transmission end and suspend from car horizontally.





3. Pull off wires for backup light switch.





4. Pull off plug on speedometer drive.





5. Push back dust cover on shift rod, remove lock wire on bolt and unscrew bolt.





6. Press leather cover for shift knob out of center console carefully and push up.





7. Remove mounting clamp for shift lever knob and take off knob.

8. Remove circlip on shift lever.





9. Turn shift lever 180°. Press down on insulation sheet and push shift rod forward into produced cavity by about 300 mm.





10. Unscrew clamping sleeve screws through assembly openings and push clamping sleeve toward transmission.





11. Push back protective tube through large opening in case far enough, that it is outside of the central pipe housing. Press in retainer with a large screwdriver for this purpose.

12. Hold transmission and central pipe in installed position placing proper size wooden block between cross tube and central pipe for this purpose.

13. Place universal transmission jack underneath the transmission and attach strap.





14. Remove transmission suspension mounting bolts.

15. Remove transmission/central pipe housing mounting bolts.

16. Pull back transmission and run out downward carefully.