Clutch Installation

- Install pre-loaded pressure plate with driven plate in clutch housing, center drive plate with central shaft in deep-groove ball bearing of crankshaft and tighten mounting bolts 1 to 1/2 turns.
- Fit guide tube. Make sure that the guide tube is seated correctly in the corresponding cutout in the clutch bell housing and that the entire contact surface of guide tube and clutch bell housing is in contact.
- Engage release lever by placing ball and socket opposite each other and pressing release lever down and back until it is felt to engage.
- Attach clamping sleeve to central shaft first. Align holes of clamping sleeve on shafts.
- Uniformly tighten mounting bolts of presure plate. Tightening torque 22 Nm (16 ft lb) remove angles (3 of).
- Check centering pins. Using a depth gauge, measure from the rear of the flywheel (engine side) through the bore to the centering pin (approx. 4 mm).
- Insert slave cylinder into clutch bell housing and tighten cover. Then fit slave cylinder into place.