General Information

Application

The System tester 9288 (BOSCH KTS 301) is a microprocessor-controlled self-diagnosis tester.

All systems which have a diagnosis interface as per ISO Standard can be tested with this tester. The following tests are possible:

^ Reading out the fault memory
^ Testing of the actuators
^ Testing the circuit inputs
^ System adaptation
^ Engine-knock detection
^ Sensor and status checks, tire-pressure monitoring (RDK)

CAUTION: The System tester 9288 is a high-quality piece of electronic equipment. In order to prevent damage to the equipment ass result of improper use, please read the information in the operating instructions carefully and comply with it. In addition, the instructions (specifications) of the vehicle manufacturer are also to be observed.

If the tester should fail, check the following points before sending it in for repair:

1. Has the tester been operated incorrectly?
2. Is the battery sufficiently charged?
3. Is the adapter cable OK?

CAUTION: (Please note when checking the adapter cable that a highly sensitive electronic matching circuit it installed in the vicinity of the 19 pole plug).

Battery charger run off mains voltage (No. 3)
- Accessory -
Item 1 Charger with connecting cable, 1.5 m long
Item 2 8-pin AMP plug

Vehicle-specific adapter cable
Porsche No. 000 721 928.81

Connecting lead
- Self-fabrication -
For printer, program load station or similar unit.
For interface-trunk assignment, see manual of corresponding unit.
Printer cable for standard D 25 BOSCH No. 1 684 465 193
Printer cable for EPSON BOSCH No. 1 684 465 194