Crankcase Tightening Specifications

Crankcase Tightening Specifications

Crankcase Tightening Diagram (Part 1 Of 2):

Crankcase Tightening Diagram (Part 2 Of 2):

Tighten bolts and studs with 50 Nm (36.9 ft lb). Note specified tightening sequence shown in the illustration.

NOTE: A second person should always counterhold while tightening, to avoid damaging the O-rings while turning the bolts. Use a M14 wrench socket from "Snap-on" or equivalent.

Tighten outer crankcase bolls with a final torque of 25 Nm (18 ft lb).