With Tiptronic
Removing and flange-mounting the engine-transmission assemblyRemoving from flange
1. Remove starter.
2. Undo torque converter fixing screws (M 6 x16) and unscrew. (8 each).
3. Hang holding device 9325 behind the starter gear ring.
Note: During removal and flange-mounting, the holding device prevents the torque converter from falling out.
4. Hook transmission holder 9324 in the mounting bores of the transmission case. Make sure that it is fitted correctly.
5. Suspend transmission holder from workshop crane and slightly pre-tension workshop crane.
6. Undo transmission ring screw connection and disconnect or pull off Tiptronic transmission from engine.