Test Point 18 - VarioCam
TEST POINT 18 - VarioCam - Fault code 1_35Possible Causes, Elimination, Remarks
Using the System Tester 9288, VarioCam may be checked directly in the Drive links menu item or the Drive link active test point. A switching noise must be audible in case of the Drive links test point. For the Drive link active menu item, the entire system is checked with the engine running. With this test, there is a risk of the engine stalling due to valve overlap. This causes communication to the System Tester 9288 to be interrupted. To be able to continue the diagnosis, switch the ignition off and back on again. Then press the ">" key on the System Tester.
- If VarioCam is not triggered, disconnect plug at the solenoid. Switch ignition on. Connect voltmeter to plug (refer to drawing) and ground (engine).
Display: Battery voltage
No display: Check wiring according to wiring diagram