Engine/Transaxle - Hardware Replacement During Service

Group
1

Number
9601

Model
6 Cyl.

Part Identifier
1001

Subject:
Replace Hardware when Removing Engine / Transaxle Assembly

June 6, 1996

ATTENTION:
Service Manager / Service Technician

Models Affected:
All 911 Carrera (993) and 911 Turbo (993)
Model Years 1995-on

General Information:

When the engine and transmission of a 911 Carrera or Turbo are removed for repairs, replacement of the following mounting hardware is required:

Description Qty Part Number

Nut 2 900 380 007 09 (Toe Adjuster)

Nut 6 999 084 445 09 (Eng. Mount / Rear Cross Member)

Nut 6 900 380 008 09 (Stabilizer Bar ends / Front Cross
Member)

Nut 4 900 380 005 09 (Stabilizer Bar Brackets)

Sealing Rings for steering pump (Turbo)

Ring 2 900 123 116 30
Ring 2 900 123 131 30
Ring 2 900 123 007 30

Sealing Rings for steering pump (Normally Aspirated)

Ring 2 999 701 135 50

The Dacromet torque and tension coating of the nut can only be assured through one use. It is for this reason that the nuts must be replaced during repairs.

Literature:

Refer to the 911 Carrera (993) Workshop Manual Volume 1, pages 10-2 to 10-8a and the 911 Turbo (993) Workshop Manual Volume 1, pages 10-4 to 10-12.