Spoilers - Approved Installation of Aero Kits

Group
6

Number
9610

Model
6 Cyl.

Part Identifier
6603

October 3, 1996

Subject:
Aero Kits

ATTENTION: Service Manager / Service Technician

Models Affected:

911 Carrera Model Year 1995 - on
911 Turbo Model Year 1996 - on

Concern:

Porsche approved Aero Kits for the above-mentioned vehicles.

General Information:

Porsche has approved the installation of 3 Aero Kits for use on the above-mentioned vehicles. The Aero Kits were tested as complete kits, therefore, installation of only the front or only the rear spoiler must not be done.

When installing the Aero Kits on a vehicle with a normally aspirated engine, an additional hot air connecting piece and gasket must also be installed (see additional parts listed below).

On vehicles with a retractable rear spoiler the following steps must be done to disable the spoiler warning system:

- Remove fuse # 37 from the CEB.
- Remove the spoiler warning bulb in the clock.
- Remove the spoiler switch from the center console and install a blank switch cover.
- Secure and insulate all disconnected wiring.

Vehicle Application:

Aero Kit Part Number Vehicle Application

000 044 800 29 911 Carrera without roof mount
brake light

000 044 800 28 911 Carrera with roof mount brake
light

000 044 800 16 911 Turbo and 911 Carrera 4S

Additional parts for normally aspirated engines equipped with fresh air/engine switchover flap.

Part Number Description

993 211 085 02 Hot air connecting piece
993 211 270 40 Gasket





Aero Kit Description:

Aero Kit for 911 Carrera with and without roof mount brake light.





Aero Kit for 911 Turbo and 911 Carrera 4S only.

Installation Times:

Aero Kit for 911 Carrera with and without roof mount brake light.

Installation 520 Time Units
Prep and Painting 710 Time Units

Aero Kit for 911 Turbo and 911 Carrera 4S only.

Installation 600 Time Units
Prep and Painting 790 Time Units