Removing and Installing

Removing and installing short halfshaft flange

With transmission installed

Removal

NOTE: The halfshaft flange can only be removed if the suspension is partially disconnected.

1. Remove right rear wheel, engine/transmission guard and rear underside panel.

2. Remove heating pipe.

3. Remove control arm cover.

4. Disconnect drive shaft from transmission flange.

5. Partially disconnect suspension, refer to Steering and Suspension.

NOTE: The drive shaft need not be disconnected from the wheel.





6. Unscrew fastening bolt for halfshaft flange (the illustration shows the transmission removed).





7. Lift wheel carrier using a suitable lever and take out flange (2nd person required).

Installation

1. Install the parts in the reverse order of removal.

2. Tighten screws to: 46 Nm (34 ft lb).