Sectional View 4, Roof Rail - Glass Roof

1 - Roof rail
2 Cover molding
3 - Seal
4 - Glass roof
5 - Profile frame
6 - Seal
7 - Guide rail
7a - Slide
8 - Trim section
9 - Door seal
10 - Door window
11 - Retaining strip of door seal

A powder-coated cover molding (2) is fitted to establish the joint between the roof rail (1) and the glass area. A flock-coated seal (3) mating up with the glass roof (4) is installed in the groove of the cover molding.

The powder-coated profile frame (5) is bonded to the inside of the glass roof. Another seal (6) is fitted into the profile section groove along its circumference.

The guide rail (7) is screwed to the side of the roof rail. The slide (7a) Is aligned in the guide rail.

Trim section (8) covers both the guide rails and the roof rail and is held in place by two slides at the front in addition to the screw assemblies with the coat hook.

The door seal (9) mating up with the door window (10) consists of a set of profiled sections and is screwed to the roof rail along a retaining strip (11). The fastening screws are accessible after releasing the seal from the retaining strip.