Basic Setting of Drive Motors

Basic setting of drive motors

Drive Unit:

1 - Electric motor for sun blind
2 - Electric motor for wind deflector I cover for sunroof
3 - Electric motor for wind deflector I cover for sunroof
4 - Mounting plate

Motor for sun blind

Note: The electric motor for the sun blind operates the left and right cable at the same time. A microswitch stops the motor when the sun blind has reached the fully open or closed position.

Basic setting of sun blind operating cable relative to electric motor

1. Push the left and right sun blind operating cables forwards up to the stop for the sun blind in the guide rail.
2. Connect the electric motor (1), which must not be installed at the time, to the control unit and hold the electric motor.
3. Press the sun blind rocker switch until the blind is completely rolled up and the motor is stopped.
4. Screw the motor to the mounting plate (4). The Torx T 25 M 5 x 28 mounting bolts must always be replaced as they are micro-encapsulated. Tightening torque: 3 Nm (2 ftlb).

Motor for wind deflector / cover for sunroof

Note: The two electric motors for the wind deflector cover for sunroof are operated at the same time and are mechanically interlocked by the left and right operating cables. When the completely open or closed position is reached, the two motors are stopped by a microswitch on motor (2).

Caution!
During work on the drive system, the two electric motors (2 and 3) must not be removed from the support panel at the same time. One of the motors should be left on the panel to hold the operating cables in position and to prevent displacement from left to right. If only one motor (2 or 3) is mounted on the support panel, this motor must not be operated electrically. The operating cables are not guided by the gear wheel on the motor which has been removed and could therefore be damaged.

Basic setting of wind deflector / sunroof cover operating cables relative to electric motors

1. The left and right operating cables must be moved to the closed position of sliding roof cover and wind deflector (roof closed). The slide at the front, which is connected to the cables, must touch the bearing supports at the left and right sides.
2. The two electric motors (2 and 3) must not be installed at this stage. The electric motor (1) for the blind must be connected to the control unit.
3. Connect motor (2, with microswitch) to control unit and hold motor.
4. Operate the rocker switch for the sliding roof cover I wind deflector until the sliding roof cover and wind deflector are in their final position (operate push-button four times, open and close roof twice) and the motor is stopped.
5. The electric motors (2 and 3) and the operating cables are now in the closed position. Screw the drive motors (2 and 3) to the mounting plate (4). The Torx T 25 M 5 x 28 mounting bolts must always be replaced as they are micro-encapsulated. Tightening torque: 3 Nm (2 ftlb).

Note: In emergency operation, the electric motors are only disconnected by unhooking the plastic lugs. It is only necessary to reset the operating cables if the two electric motors or operating cables have been removed.