Input Shaft

Input Shaft Disassembly/Assembly (Part 1 Of 3):

Input Shaft Disassembly/Assembly (Part 2 Of 3):

Input Shaft Disassembly/Assembly (Part 3 Of 3):

Disassembly Notes





1. Mount retaining plate 9282 in vise, fit input shaft and undo hexagon-head nut with Special Tool 9105.
2. Use a suitable tool (e.g. Kukko 17 - 1) to press all parts off the input shaft over the 2nd gear wheel.

Assembly Notes





1. To inspect synchronizing rings, press rings onto the gear wheel tapers and use a feeler gauge to measure gap "A".
- Assembly dimension:
New: 0.9 mm minimum
Wear limit: 0.6 to 0.7 mm