Drive Belt, Power Steering

Toothed Belt for Power Steering

Checking Condition
1. Remove transmission guard from transmission. Undo hot-air hose from heater flap box at air distributor pipe.





Note: Figure shows the engine removed from the vehicle.

2. Unhook clamps of air cleaner cover. Remove housing cover and filter element.
3. Undo air cleaner housing from intake air rail and unhook clamps from air flow sensor. Lift up air cleaner housing and take out housing. Be careful not to loose the O-ring in the air cleaner housing / air flow sensor.
4. Undo both 8 x 30 mm hexagon head screws on top of the hydraulic pump. Lift toothed belt cover out of engine compartment.
5. Rotate engine and check toothed belt for wear and damage.
6. The belt tension can not be adjusted.