Removal/Installation

Tightening Specifications
Engine to Engine Mount (M12) 85 Nm (63 ft lb)
Transmission Support to Body (M12) 46 Nm (34 ft lb)
Drive Shaft to Transmission Flange (M10) 81 Nm (60 ft lb)
Thermostat Housing Drain Plug (M20 x 1.5) 50+5 Nm (37+4 ft lb)
Crankcase Drain Plug (M20 x 1.5) 50+5 Nm (37+4 ft lb)
Shift rod (fit bolt) 23 Nm (17 ft lb)
Stabilizer Bar to Crossmember (M8) 23 Nm (17 ft lb)
Stabilizer Mount to Spring Strut (M10) 46 Nm (34 ft lb)
Control Arm 2 to Crossmember (eccentric) (M12 x 1.5) 85 Nm (63 ft lb)
Control Arm 2 Toe Control Arm (M12 x 1.5) 85 Nm (63 ft lb)
Rear Crossmember to Slide Sections (M12 x 1.5) 120 Nm (88 ft lb)
Front Crossmember to Side Sections (M10) 65 Nm (48 ft lb)
Pressure Pipe to Power Pump (M14) 30 Nm (22 ft lb)
Drive Shaft to Transmission (M10) 81 Nm (60 ft lb)
Wheel to Wheel Hub (M14) 130 Nm (96 ft lb)
Fuel Return Pipe 35 Nm (26 ft lb)
Fuel Feed Pipe 35 Nm (26 ft lb)
Starter Motor to Transmission 46 Nm (34 ft lb)