Transmission Position Sensor/Switch: Service and Repair

Removal

1. Set selector lever to position "N".
2. Remove transmission undertray.
3. Remove rear underside panel.
4. Remove left rear hot air pipe.





5. Disconnect selector lever cable from actuating lever.
6. Remove actuating lever.
7. Press retaining lugs for wire retainer "A" together and lift holder out upwards.





8. Detach, unlock and disconnect connector.
9. Unscrew fastening screws for multifunctional switch completely and remove switch.

Installation
For installation, proceed in reverse order.
Tightening torques:
- Multi-functional switch to transmission: 10 Nm
- Actuating lever to selector shaft: 15 Nm





1. Set selector shaft to position "N" (turn shaft anti-clockwise up to the stop and then back two clicks) and place switch in the correct position.





2. Adjusting multifunctional switch.
- Push pointer of special tool 9326 onto the selector shaft and turn the switch until the locating pin can be pushed into the fixing hole of the switch.
- Tighten the mounting screws to 10 Nm (7 ft lb) in this position.
3. Check, and if necessary adjust, setting of selector lever cable. Shift Cable