Rear Bumper: Service and Repair

Overview:

Exploded View:

CAUTION! Damage will result if deformed heat shields are fitted!
- Damaged or distorted heat shields must be straightened or replaced.

No. 1 - 10:

No. 11 - 19A:

No. 20 - 30A:

No. 31 - 43:

Additional instructions for replacing the rear spoiler







Vehicles with ParkAssistent


NOTE: Additional holes must be drilled for the ParkAssistent sensors in the rear spoiler before this component is painted.


Drill holes in accordance with the markings inside the rear spoiler.
1. Drill holes "A" with dia 6 mm.
2. Enlarge holes "B" to dia 35 mm using a stepped drill or a center bit.
3. Check holes by putting on a disc of the ParkAssistent sensor or by inserting the sensor.
4. Rework the holes if necessary.

USA model


NOTE: Additional cut-outs must be made for the impact horns in the rear spoiler before this component is painted.


1. Saw out cut-outs "C" in accordance with the markings inside the rear spoiler.