Pre - Sales Check

Fitting roll cage - GT3

General

The screwed roll cage is not fully fitted on vehicle delivery if the vehicle is supplied with Club Sport equipment.
The front sections (A-pillar support) of the roll cage which are delivered separately from the vehicle must be fitted on to the base cage.

Note: Do not tighten any of the screwed points until the screws have been screwed in. Use correct tightening torques!

Fitting left section





1. Insert the left section of the roll cage (A-pillar support) from the left door and position at the rear on the screwed points of the base cage. Fasten with the M 8 x 12 hexagon socket head bolts.
Tightening torque: 23 Nm (17 ft. lbs.)





2. Position the section (A-pillar support) on the screwed points at the front. Position the counterplate on the outside of the vehicle underbody and fasten with the M8 x 25 hexagon-head bolts, 8.4 washers and the M8 fastening nuts.
Tightening torque: 23 Nm (17 ft. lbs.)

Fitting right section





3. Insert the right section of the roll cage (A-pillar support) from the right door and position at the rear on the screwed points of the base cage. Fasten with the M 8 x 25 hexagon-head bolts.
Tightening torque: 23 Nm (17 ft. lbs.)





4. Position the section (A-pillar support) on the screwed points at the front. Position the counterplate on the vehicle underbody on the outside and fasten with the M8 x 25 hexagon-head bolts, 8.4 washers and the M8 fastening nuts. Tightening torque: 23 Nm (17 ft. lbs.)





5. Fasten the transverse connection between both sections with the M 8 x 12 hexagon socket head bolts.
Tightening torque: 23 Nm (17 ft. lbs.)