Lighting and Horns: Application and ID

Bulb Table And Installation Instructions

Bulb table
Lamp Shape, Output

High beam headlight, dipped beam D2S, 35 W
headlight (Bi-Xenon headlight
as from MY `02)
Auxiliary high beam headlight H 11, 55 W
(Bi-Xenon headlight as from MY `02)
High beam H7, 55 W
High beam headlight as from MY `02 H9, 65 W
Dipped beam headlight (Litronic D2S, 35 W
headlight up to MY `01)
Dipped beam headlight H7, 55 W
Fog light H7, 55 W
Fog light as from MY `02 H 3, 55 W
Front parking light (Litronic, Bi-Xenon H, 6 W
headlight as from MY `02)
Front parking light (up to MY `01) W, 5 W
Direction indicator, front and rear PY, 21 W
Direction indicator (USA) MSCD 40
Direction indicator, side W, 5 W
(MY `98 and USA)
Direction indicator, side (as from WY, 5 W
MY `99)
Rear fog light P, 21 W
Reversing light P, 21 W
Brake light/tail light P,21 W
Tail light (only C4S) P, 5 W
Tail light R, 5 W
Additional brake light W, 3 W
Number plate light C, 5 W
Luggage compartment/engine K, 10 W
compartment light, interior light
Reading light 6 W Xenon
Door lock/exit light W, 5 W

Installing bulbs

CAUTION: Danger of damage to property if bulbs are used or handled incorrectly.
Danger of injury. When installed, the headlight is under high voltage.
- Only bulbs specified in the bulb table may be used.
- Bulbs with a higher wattage may cause damage to the bulb housing.
- To prevent short circuits, the load in question must be switched off while bulbs are changed.
- New bulbs must be clean and free of grease. Therefore, never touch bulbs with your bare hands: To change the bulbs, use a cloth or soft paper.
- Observe the safety instructions when replacing a bulb in a Litronic or Xenon headlight.
- In certain states, it is compulsory to carry spare light bulbs.