Removal

1. Switch off ignition. Remove cover -A + B- and battery cover.

2. Remove spare wheel (if present).





3. Remove brake booster -C- --> 47-10 "Removing and installing brake booster".

Note!
^ To remove and install brake booster -C-, the brake master cylinder -B-, the hydraulic unit -D- and the booster pump -A- in vehicles with PSM must be removed!

^ The assembly of the brake master cylinder -B- with the brake booster -C- must not be disconnected for removal and installation if both parts should be continued to be used!





4. Remove battery -1- (necessary to remove intermediate piece no. 11)! Remove alarm horn on the intermediate piece -11-.

5. Undo intermediate piece -11- arrow- (2 M8 nuts and hexagon socket head bolt) and remove in the direction of the battery. Unclip air-conditioning line -2- from the holder.





6. Remove the bellows -1- on the fire wall and the bellows -2- on the brake booster. Pull off the grommet (rubber groove ring) -3-.

Note!
The grommet -3-is not replaced!





7. Undo brake pushrod -9- on the brake pedal and remove.

Note!
The former brake pushrod -9- with guide (double rib) -arrow- is to be replaced with the brake pushrod -9.1- without guide!