Mount the Holder on the Wall

- available space, type of walls, presence of electrical wiring and plumbing within walls.

- strength and condition of the wall, and the height (at least 230 cm).





2.1 Screw studs into the tube clamps. Engage the tube clamps in the area of the outer bores (at right angles) on the long cross tube.

Position of tube clamps with respect to each other:

- Dimension B (figure 3) approximately 147.5 cm (58") or approximately 2 cm (3/4") next to the bore in direction of the connector tube.

Note:
Bores at the end of the long cross tube must not be covered by the tube clamps.

2.2 Hold the holder horizontally against the wall and mark the bores for the pipe clamps on the wall according to the dimensions.

- distance of the short cross tube (figure 3, dimension C) from the floor: at least 55 cm (32") and

- distance from the end of the groove in the plastic fork (dimension D) to the ceiling at least 60 cm (24").

2.3 Drill holes 1O mm (3/8"), depth approx. 50 mm (2") in the wall for the tube clamps. Insert S10 plug-in pins into the bores.

Note:
These mounting steps take into consideration the wall is made of concrete, brick, etc. When mounting on a wall constructed with other materials (such as wooden studs and sheet rock) please consult your local building codes before attempting any installation.

2.4 Screw tube clamps into the plug-in pins until only the metric thread of the stud remains visible and the open side of the tube clamps faces upward.

2.5 Hang holder in the pipe clamps and align horizontally (refer to 2.1). Close the tube clamps, but do not screw them down yet.





2.6 Remove screw (figure 4 item A) from the free leg of the clamping piece (elbow shape). Insert sleeve (item B) into the clamping piece and transfer bore to the wall.

2.7 Drill a hole 8 mm (5/16"), depth approx. 50 mm (2") at the mark and insert S8 pin in to the Bore.

2.8 Insert multipurpose screw 6 x 60 mm into the sleeve and screw sleeve to the wall.

2.9 Guide clamping piece (elbow-shaped) onto the sleeve, align, and screw together with the sleeve.