Safety Instructions For Assembly Work
Safety instructions for airbag system
CAUTION:
Danger of injury due to triggering of airbag units while ignition key is still in ignition!
- Always remove ignition key during body work, and do not commence adjustment work until a waiting period of at least 1 minute has elapsed!
- The ground strap of the battery must be disconnected during work on the airbag system and alignment bench work within the framework of body repair!
Safety instructions for sliding roof
CAUTION:
Damage to water drainage channel and sliding roof mechanism when sliding roof panel is removed!
The rear water drainage channel or the sliding roof mechanism is damaged if the sliding/tilting roof trim is moved incorrectly!
- The sliding roof mechanism must not be moved to the "Open" position when the sliding roof panel has been removed!
- In order to avoid damage to the guides of the sliding roof, it must be possible to move the sliding/tilting roof panel (Item 4) without the use of excessive force!
Safety instructions for rear spoiler
WARNING:
Danger of injury and danger of damage to the vehicle due to changed handling if the adjustment of the additional wing is changed!
- The additional wing must be moved to the lowest position for use in public traffic!
Safety instructions for cabriolet convertible top
CAUTION:
Damage to tension bow seal if convertible top is actuated electrically in service position!
- The convertible top must no longer be electrically moved in service position!
CAUTION:
Damage to convertible-top frame if not running synchronously during bleeding!
- The hydraulic system may be bled only if the hydraulic cylinders are removed from the convertible-top supports and drive levers on both sides!
CAUTION:
Short circuit and burns on convertible top if wire strands are crossed!
- Wire strands must not be crossed!
Safety instructions for roll-over protection system
WARNING:
Danger of injury if roll-over bar is actuated when roll-over bar module is being removed!
- Remove the roll-over bar modules only after the roll-over bar has been extended (triggered)!
Safety instructions for hydraulic system
CAUTION:
Danger of damage to hydraulic system if hydraulic lines are bent, trapped or crushed during installation!
- Do not bend, trap or crush hydraulic lines during installation!