Disassembling and Assembling Hardtop
Removal overview of the hardtop components
Steps 1 - 8:
1 Removing cover strips and roof strip clips
2 Unclipping inner lining
3 Detaching seal at sides of roof frame
4 Detaching and disengaging retaining rail and roof frame seal at the comers
5 Detaching rubber seal
6 Detaching roof liner at front
7 Detaching roof liner at sides
8 Detaching roof liner at rear and transverse struts
Steps 9 - 15:
9 Detaching insulation from the hardtop body
10 Removing foam strips and foam pads
11 Removing locking lever
12 Removing centering peg
13 Removing hardtop locking element
14 Disconnecting wiring harness of the heated rear window
15 Pressing expanding nuts out of the hardtop body
Disassembling hardtop
Procedures No. 1 - 2:
Procedures No. 3 - 5:
Procedures No. 6 - 8:
Procedures No. 9 - 11:
Procedures No. 12 - 14:
Procedure No. 15:
Installation overview of hardtop components
Steps 1 - 9:
1 Pressing expanding nuts into the hardtop body
2 Fitting wiring harness of the heated rear window
3 Fitting hardtop locking element
4 Sticking felt strips on inside of window aperture
5 Sticking insulation on the hardtop body
6 Fitting centering pin
7 Fitting locking lever
8 Sticking in foam strips and foam pads
9 Engaging roof liner at rear and transverse struts
Steps 10 - 17:
10 Engaging roof liner at sides
11 Fitting roof liner at front
12 Fitting rubber seal
13 Adhering Nito tape on the front left and right of the hardtop body
14 Fitting retaining rail and roof frame seal at the corners
15 Fitting seal at sides of roof frame
16 Clipping in inner linings
17 Fitting cover strips and roof strip clips
Assembling hardtop
Procedures No. 1 - 2:
Procedures No. 3 - 5:
Procedures No. 6 - 8:
Procedures No. 9 - 11:
Procedures No. 12 - 14:
Procedures No. 15 - 17:
