Additional Instructions For Replacing The Rear Spoiler

Additional Instructions For Replacing Rear Spoiler:

NOTE:
- Additional cut-outs must be made for the impact horns (USA version) in the rear spoiler before the new component is painted.
- For the Park Assistent equipment version, no additional bore must be made on the new component. A special spare part is available for this version which contains the bores and retainer plates to hold the Park Assistent.


1. Drill hole -C- in accordance with the markings inside the rear spoiler.
2. Saw out cut-outs -B- in accordance with the markings inside the rear spoiler.
3. Slant the upper and lower cut edges of the cut-outs -B- at an angle of -40°- (see cut -A-A-).