Removal and Replacement

Installing cylinder head








1. Fit cylinder head gaskets.

Information
^ The gaskets are identified by Zyl. 1 - 3 or Zyl. 4 - 6 with OBEN/TOP, plus the corresponding part number.





Ensure correct seating of dowel sleeves in crankcase. Put on gaskets.





2. Fasten cylinder heads. Moisten cylinder-head screws thinly with engine oil.

Initial Tightening:

Final Tightening:

Cylinder Head Tightening Sequence:

Torque Angle Tightening (60 Degrees):

Diagram shows torque-angle tightening with 60°

3. After tightening the cylinder-head screws, additionally fasten four pan-head screws M6 x 35 (10.9) (with captive washers) in the area of the chain box. Tightening torque 13 Nm (10 ftlb.)

Four Pan-Head Screws (M6 x 35):