Safety Instructions For Installation Work
Safety instructions For Installation Work
Safety instructions for airbag system
CAUTION: Danger of injury due to unintentional activation of airbag units!
- The ground strap of the battery must be disconnected during work on the airbag system and alignment bench jobs when the body is being repaired!
- After the battery is disconnected, assembly work or work on the vehicle with a hammer or similar tools may not be started until after a waiting period of 1 minute!
Safety instructions for sliding roof
CAUTION: Damage to water drainage channel and sliding roof mechanism when sliding roof panel is removed! The rear water drainage channel or the sliding roof mechanism is damaged if the sliding/tilting roof trim is moved incorrectly!
- The sliding roof mechanism must not be moved to the "Open" position when the sliding roof panel has been removed!
- In order to avoid damage to the guides of the sliding roof, the sliding/tilting roof trim (Item 4) must be moved without the use of force!
Safety instructions for rear spoiler
WARNING: Danger of injury and danger of damage to the vehicle if handling is modified when adjusting the additional wing!
- The additional wing must be moved to the lowest position for use in public traffic!
Safety instructions for convertible top
CAUTION: Damage to tension bow seal if convertible top is actuated electrically in service position!
- The convertible top must no longer be electrically moved in service position!
CAUTION: Damage to convertible-top frame if not running synchronously during bleeding!
- The hydraulic system can be bled only if the hydraulic cylinders are removed from the convertible-top supports and drive levers on both sides!
CAUTION: Short circuit and burns on convertible top if wire strands are crossed!
- Wire strands must not be crossed!
Safety instructions for roll-over protection system
WARNING: Danger of injury if roll-over bar is actuated when roll-over bar module is being removed!
- Remove the roll-over bar modules only after the roll-over bar has been extended (triggered)!
Safety instructions for hydraulic system
CAUTION: Danger of damage to hydraulic system if hydraulic lines are bent, trapped or crushed during installation!
- Do not bend, trap or crush hydraulic lines during installation!
Model year as of 1997