Removal and Installation

Removing and installing clutch




Tools

Assembly instructions
Removal
1. Remove manual transmission. Service and Repair





2. Fasten toothed segment (special tool 9538/1) on the crankcase half (cylinder bank 1 - 3) with hexagon-head bolt M12 x 50.
3. Detach thrust plate.

Note: In order to avoid deformation of the thrust plate housing, always loosen screws in several stages and in diametrically opposite sequence.

4. Remove thrust plate and drive plate.

Installation
1. Fit centering mandrel (special tool 9102) with drive plate in the guide bearing (needle bush).
2. Fit thrust plate. Always tighten pan-head screws in several stages and in diametrically opposite sequence. Tightening torque: 23 Nm (17 ft. lbs.)
3. Remove centering mandrel.