Removal and Installation

Removing and Installing Clutch - GT2





Tools


Removing Clutch

1. Remove transmission See Removing and Refitting the Transmission.





2. Position the toothed segment P201b -A- on the stud and undo the pan-head screws in several stages and in diametrically opposite sequence, to avoid deforming the thrust plate.


Installing Clutch

1. Fit drive plate with centring mandrel, special tool centring mandrel 9102 in the guide bearing (needle bush).





2. Fit thrust plate. To do so, position the special tool toothed segment P201b -A- on the stud and tighten the pan-head screws in several stages and in diametrically opposite sequence.
Tightening torque: 23 Nm (17 ftlb.)

3. Remove the special tool centring mandrel 9102.

4. Remove the special tool toothed segment P201b.

5. Refit transmission. See Removing and Refitting the Transmission.





Tightening Torques