Installing Air Cleaner Housing

Removing And Installing Air Cleaner Housing







Installing air cleaner housing - Cayenne Turbo (type M48/50)
1. Insert the air cleaner housing into the engine compartment at an angle from above.







2. Insert the two fastening pins on the underside into the take-up bores in the body. Check the wheel well to make sure that the blue rubber discs are present and ensure that the pins are properly fitted.







3. Replace the air guide on the air cleaner housing from the wheel well. Check that the elements are installed correctly.







4. Tighten the fastening screw on the air cleaner housing to 10 Nm (7.5 ftlb.).







5. Clip the electrical cable from the coolant expansion tank onto cylinder bank 1 - 4. The cable is clipped in at two points.







6. Insert filter element in the housing.







7. Place the cover on the air cleaner housing and run it in from top to bottom. Make sure that the three fastening lugs run into the mounting points on the underside. The figure gives a clearer view of the dismantled air cleaner housing.







8. Push cover up against the air cleaner housing and lock the two fastening clips.







9. The coolant bleeder hose and the coolant overflow hose must be clipped back onto cylinder bank 1 - 4 on the air cleaner housing.







10. Push the air suspension line onto the right air cleaner cover.
11. Push the connections onto the cover of the air cleaner housing and mount and lock the fastening pins.







NOTE: The air cleaner housing of cylinder bank 5 - 8 is installed in the same way.

12. Install left and right engine compartment cover.
13. Install the wheel housing liner.

Tightening torques