Allocating the Front-Axle Cross Member to the Body
Allocating the front-axle cross member to the bodyCaution:
Material damage will result in the area of the axle mount/axle fastening due to reduced strength, if correct allocation is not observed!
^ Only install permissible combinations of front-axle cross member to the body (standard construction)!
^ Do not install front-axle cross members with one fastening screw (F1) in vehicles with two body mounting points (K2)!
Impermissible combination
Front-axle cross member with one fastening bore -F1- and body with two fastening points -K2-.
^ Attention: Impermissible combination!
Permissible combinations
Front-axle cross member with one fastening bore -F1- and body with one fastening point -K1-.
^ Standard construction up to end model '01.
Front-axle cross member with two fastening bores -F2- and body with two fastening points -K2-.
^ Standard construction as of model '02.
Impermissible combination
The combination - front-axle cross member with two fastening bores and (F2) and body with one fastening point (K1) - is not possible!