Roll Bar: Adjustments

Adjusting the roll-over bar







The foam coating of the A-pillar support sections must be pressed against the cowl panel frame trim.
1. Unscrew the adjusting element -2- in the direction of the arrow -Y- until the foam coating of the A-pillar support sections on the left and right -A, B- are pressed against the cowl panel frame trim.
2. Screw the lock nut -1- in the direction of the arrow -X- as far as it will go against the adjusting element -2- and lock it against the adjusting element -2-.


Assembly instructions for the rear trim, the floor covering and the closure caps







Tightening torques