Overhaul

Disassembling And Assembling Rear Lid







Disassembling rear lid










Assembling rear lid










Removing and installing additional brake light

1. Removing additional brake light







1.1. Unclip cover -A- at the sides, unlock lock -B-. Remove brake light and disconnect plug connection -C-.

2. Installing additional brake light







2.1. Push on plug -C-. Insert brake light. Lock lock -B-. Clip in cover -A-.

Removing and installing wiring harness

Removing wiring harness







1 - Press the lug of the electrical plug connection, see inset -arrow- and disconnect.
2 - Remove additional brake light.
3 - Pull out grommet -A- with brake light lead. Disconnect plug connection -B- for fan on fan housing. Disconnect plug connection for engine compartment lighting -C-. Press fastening clips -arrows- together from the inner side of the mount and remove.

Installing wiring harness







Replacing model logos

Replacing the Carrera 4 model logo up to model year 2001







1. Find the middle of the lid.
2. Position the -Carrera- logo with the dimensions -A and B = 129.6 mm- and -C = 35 ± 1 mm- on the rear lid and affix.

Replacing the Carrera 4 model logo up to model year 2001







1. Find the middle of the lid.
2. Position the -Carrera- logo with the dimensions -A and B = 162.6 mm- and -C = 35 ± 1 mm- on the rear lid and affix.

Replacing the GT3 model logo







1. Find the middle of the lid.
2. Position the -GT3- logo with the dimensions -A and B = 78.2 mm- and -C = 28 ± 1 mm- on the rear lid and affix.

Replacing the Carrera model logo as of model year 2002







1. Find the middle of the lid.
2. Position the -Carrera- logo with the dimensions -A and B = 129.6 mm- and -C = 29 ± 1 mm- on the rear lid and affix.

Replacing the Carrera 4 model logo as of model year 2002







1. Find the middle of the lid.
2. Position the -Carrera 4- logo with the dimensions -A and B = 162.6 mm- and -C = 29 ± 1 mm- on the rear lid and affix.

Replacing the Targa model logo







1. Find the middle of the lid.
2. Position the -Targa- logo with the dimensions -A and B = 98.4 mm- and -C = 29 ± 1 mm- on the rear lid and affix.

Replacing the Forty fast years model logo







1. Find the middle of the lid.
2. Position the -Forty fast years- logo with the dimensions -A and B = 124 ± 2 mm-, -C = 20 ± 0.5 mm- and -D = 8.5 mm- on the rear lid and affix.

Test and adjusting values

INFORMATION:
- Illustration of the gap dimensions.
- Until model year 2001 Refer to Diagram - body gap dimensions.
- As of model year 2002 Refer to Diagram - body gap dimensions.







Tightening torques