Left/Right Traffic Conversion For Litronic Headlights

Left/right traffic conversion for litronic headlights

WARNING
Warning signs (yellow triangle with black high-voltage arrow) indicate high voltage (risk of fatal injury).

- The light should always be switched off when the components (control module, ignition unit, gas discharge lamp, drive motor) are removed and installed. A removed headlight does not have a high voltage.
- The gas discharge lamp (D2S lamp) should only be operated when installed in the reflector and in the installed headlight.

NOTE: The masking film for left/right-hand traffic should not be removed from Litronic headlights. In the headlight there is a changeover lever for driving in countries with left or righthand traffic. The changeover lever is located on the left and right of the housing in front of the gas discharge lamp.

Converting Litronic headlights
1. Switch off light. Disengage headlight housing and pull forwards a little.
2. Disconnect the electrical plug connection of the automatic headlight beam adjustment (ALWR) take out headlight housing.
3. Release cover with control module and open.






4. Put changeover lever A into position T (tourist setting).

Installation
1. Lock cover with control module and insert headlight housing into the wiring.
2. Engage the electrical plug connection of the automatic headlight beam adjustment and lock the headlight housing into the wing.
3. Repeat conversion for other headlight.