Removal and Replacement

Removing And Installing Roll-Over Bar










INFORMATION:
- To make taking measurements easier during installation of the roll-over bar, the number of shim plates -2, 3- should be kept the same.
- The roll-over bar -2- can be removed together with the convertible-top if:

The convertible top is in the service position. Refer to Removing and installing convertible top.
The three-point belt on the body is removed. Refer to Removing and installing front three-point belt
The push bar of the convertible-top gear has been uncoupled. Refer to Removing and installing convertible top.
The side-panel lining is removed. Refer to Removing and installing side-panel lining







Adjusting the roll-over bar







The roll-over bar is measured in production in the vehicle and fixed with dowel pins -6- and dowel sleeves -4- on the left and right sides.

The dowel sleeves -4- and dowel pins -6- must not be removed.

1. Adjustment procedure: Unscrew collar nuts -1- at the screwed points front and rear.
2. Lift roll-over bar and insert or remove shim plates -2, 3- according to the test and adjusting values.
3. Tighten collar nuts -1-.

Test and adjusting values







Tightening torques