Cellular Phone: Service and Repair

Removing And Installing Console For Telephone







Removing Console For Telephone







1. Release interface box "a" and pull it down and off.







2. Unscrew fastening screw "4" from upper part "E", raise upper part and leave it hanging forwards.







3. Unscrew fastening screw "3" from inner part-outer part "A-D", pull side panel to the left and leave it hanging out.







4. Undo the three fastening screws "2" from the clamp "B" and remove clamp.
5. Remove the outer part "D" with the cable duct "C" from the holder on the centre console.







6. Pull the VDA interface and antenna wire under the centre console and disconnect it, then remove the upper part with the cradle.

Centre console "G"
Seat "F"

Installing Console For Telephone







1. Fit the upper part "E" loosely to the outer part "D" and lay the VDA interface wire and antenna wire in the outer part "D".
- Make sure that the wires are not pinched.

2. Engage the cable duct "C" in the outer part "D".







3. Lift the assembled components "C, D, E" onto the centre console holder, engage the cable duct at the lower edge of the centre console, and push the components "C, D, E" onto the centre console holder.
4. Place the clamp on the outer part and secure with the three fastening screws "2". Refer to 'Tightening torques'







5. Engage the inner part "A" with the outer part "D", clip into the outer part and secure with the fastening screw "3". Refer to 'Tightening torques'







6. Engage the upper part "E" with the inner-outer part "A-D" and secure with the fastening screw "4". Refer to 'Tightening torques'
7. Push the interface box onto the cradle from below until the interface box engages.
8. Connect wire for the VDA interface and antenna wire.







9. Push the wire under the centre console by raising the centre console.

Centre console "G"
Seat "F"

10. Move the seat to the position required by the customer.

Tightening Torques