Installing

Installing double-mass flywheel

Note: Before re-installation, clean the friction surface of the flywheel with a clean lint-free cloth that has been soaked in solvent naphtha or acetone.

1. Position double-mass flywheel on the crankshaft's dowel pin and press on to the crankshaft flange. Insert all fastening screws (8).
2. Align toothed segment 9538/1 and tighten fastening screw again.
3. Screw in and tighten fastening screws in diagonally opposite sequence. Initial tightening 19 ft. lbs.; Final tightening - torque angle 120°
4. Remove toothed segment.

Subsequent work
Subsequent work for double-mass flywheel
1. Install clutch.
2. Install manual transmission.