Removing and Installing the Driver's Airbag Unit

695819 Removing And Installing The Driver's Airbag Unit

Remove driver's airbag unit
1. Remove ignition key.
2. Disconnect the battery and cover terminal or battery.
3. Undo the -fastening screws- (2 ea.) with a socket wrench insert for inside Torx T 30 (at least 50 mm long).







NOTE:
- The self-locking screws must be replaced every time they are undone.
- To do this, undo the retaining bracket of the airbag unit (3 screws) in the steering wheel.

4. Disconnect the electrical plug connection.


WARNING: Danger of injury and damage to property as a result of incorrect handling of airbag units.

Please observe the following points:
- The airbag unit must always be deposited so that the airbag opening faces upwards.
- If removed for an extended period, the airbag unit must be kept in a locked place.
- Observe the safety regulations.

Installing driver's airbag unit
1. Tightening torque for fastening screws (2 screws M6 x 16): 10 Nm (7.5 ftlb.)

2. Tightening torque for retaining bracket (3 screws M5 x 20): 5 Nm (3.5 ftlb.)