Convertible Top Control Module

Connector Assignment, Control Module

Pin Locations:

Connector 1

1 - "0pen" button
2 - Comfort opening
3 - Hardtop status
4 - Not used
5 - Convertible top locked
6 - Terminal 15
7 - Not used
8 - Switch for engine compartment lid
9 - Convertible top raised
10 - Raise door windows
11 - Alarm CM
12 - Convertible-top potentiometer, negative
13 - Speed
14 - "Close" button
15 - Comfort closing
16 - Diagnosis K-line
17 - Not used
18 - Parking brake
19 - Micro-switch for convertible-top compartment lid (CTCL) locked
20 - Convertible top unlocked
21 - Signal from convertible-top potentiometer
22 - Lower door windows
23 - Convertible-top pilot
24 - Convertible-top potentiometer, positive
25 - Electronic ground
26 - Terminal 30

Connector 2

1 - Drive for locking roof frame
2 - Drive for unlocking roof frame
3 - Terminal 31
4 - Terminal 30

Connector 3

1 - CTCL potentiometer, positive
2 - CTCL motor to positive
3 - Signal from CTCL potentiometer
4 - CTCL motor at positive
5 - CTCL potentiometer, negative

Connector 4

1 - Open convertible top
2 - Motor to extend right rear section flap
3 - Motor to extend left rear section flap
4 - Motor to retract left rear section flap
5 - Motor to retract right rear section flap
6 - Close convertible top
7 - Micro-switch, right rear section flap up
8 - Micro-switch, right rear section flap down
9 - Micro-switch, left rear section flap up
10 - Micro-switch, left rear section flap down