Removing and Installing Rear Side Window - Cabriolet

Removing And Installing Rear Side Window - Cabriolet

Removing side window

Release the side window from the clamping jaws of the rear power window with the side-panel lining and rear side window inner seal removed and the side window extended. To do this press the micro-switch in the windscreen frame and actuate the rocker switch at the same time until the side window is completely extended. Refer to Removing and installing rear power windows (Cabriolet)

Lift the side window upward out of the rear side section slot.

Installing side window

1. Installing the side window in the clamping jaws







1.1. The convertible top must be open to fit the side window. The power window must be in the upper position. Insert the side window through the side section slot into the clamping jaws of the front and rear drivers -arrows-.

2. Adjusting the side window angle in the vehicle longitudinal direction







2.1. Moving the side window into the clamping jaws on the receiving rollers equalizes the angle of the side window to the door window. The window bottom edge must lie against the receiving rollers in the clamping jaws -inset-. Adjust side window to contour of door window and the -gap E = 9 mm-. Tighten the clamping jaws after completing the adjustment.

3. Adjusting the lower stop of the power window unit







3.1. It is possible to adjust the height of both lower stops -arrows-. However, this should only be adjusted synchronously. The adjustment is only possible when the side window is lowered.


Tightening torques







Test and adjustment values