License Plate Lamp: Service and Repair

Removing And Installing Bulb For Number Plate Light

Removing bulb for number plate light

Removing number plate light

CAUTION:
Danger of damage to property if bulbs are used or handled incorrectly.
- Risk of damage to bulbs and bulb housing.
- Switch off ignition and remove ignition key.
- To prevent short circuits, the load in question must be switched off while changing bulbs.
- Only bulbs specified in the bulb table may be used.
- Bulbs with a higher wattage may damage the bulb housing.
- New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands. Use a cloth or soft paper when changing bulbs.
- In certain states, it is compulsory to carry spare light bulbs.












1. Unscrew the two fastening screws and remove the number plate light.

Removing bulb for number plate light







1. Remove defective bulb from between the contact springs.

Installing bulb for number plate light

INFORMATION: Only use the relevant bulb specified in the bulb table.







1. Insert new bulb into the contact springs.

Installing number plate light












1. Insert number plate lights and tighten with the two fastening screws.