Installation

Installation





1. Insert valve -5- with the fitted foot seal -(6)- into the wheel. The foot seal -6- is always fitted with new valves!





2. Place O-ring -4- carefully on to the valve from the outside. Mount disc -3- in the correct position -arrow-. The O-ring then lies in the disc depression.





3. Install the fastening nut -2- with the shaft facing towards the valve foot. Tighten the fastening nut -2- with a torque wrench to 3.5 (2.5 ft. lbs.) ± 0.5 Nm (0.5 ft. lbs.). When tightening, counter with a screwdriver on the slot of the valve foot.